EMLID Navio2 kit

Numéro d'article: 031-11970


249,00 €

exkl. 19% TVA , livraison port gratuit

Délai de livraison: 1 - 3 jours ouvrables



Autopilot HAT for Raspberry Pi powered by ArduPilot and ROS.

Turn your Raspberry Pi into a drone controller by using the might of sensors and controllers on board.

GNSS receiver – Tracks GPS, GLONASS, Beidou, Galileo and SBAS satellites. External antenna with MCX connector.

Dual IMU – Accelerometers, gyroscopes and magnetometers for orientation and motion sensing.

RC I/O co-processor – Accepts PPM/SBUS input and provides 14 PWM output channels for motors and servos

High resolution Barometer – Senses altitude with 10 cm resolution

Extension ports – Exposed ADC, I2C and UART interfaces for sensors and Radios.

Triple redundant power supply – With overvoltage protection and power module port for voltage and current sensing.

Product characteristics

  • Dimensions: 55mm x 65mm
  • Weight: 23g
  • Operating temperature: -40 to +85 ºC
  • Supply voltage: 4.75 – 5.25 V
  • Power supply: Power module, servo rail, USB
  • Average current consumption: 150mA
  • Ports: Power module, UART, I2C, ADC, 14 PWM servo outputs, PPM/S.Bus input
  • ICs: MPU9250 9DOF IMU, LSM9DS1 9DOF IMU, MS5611 barometer,U-blox M8N GLONASS/GPS/Beidou (antenna connector type MCX), Cortex-M3 RC I/O co-processor, RGB-LED

Delivery content

  • 1x Navio2 Board
  • 1x Connector for RPi
  • 4x Spacers
  • 8x M2.5 screws
  • 1x GPS/GNSS Antenna for Navio2
  • 1x Power Module for Navio2
  • 1x Wire Pack for Navio2
Dates de contact
question sur le produit