In this online training course, we show you how to get started and how to take the first steps with your Emlid Reach receiver. We will explain the hardware setup and the settings in the software via video call.
If you wish, we can access your hardware remotely so that we can show you our tips and tricks directly on your device.
We also provide further important information for GNSS measurement as part of this training Course.
Contents of the training
- Initial installation of necessary firmware and software
- Getting to know the hardware and software
- Possible applications
- Possible combination options
- Hints, tips & tricks
- Customer-specific data processing
Duration of the training
- The training lasts about 2 hours, depending on the level of knowledge and application.
Procedure of the training
You can book the training course when you purchase an Emlid Reach Receiver.
- After making an appointment, we will meet in a video chat portal of your choice. There everything will be set up and presented according to your wishes.
- If required, it is also possible to access your control unit for the receiver via remote control and explain it even more clearly.
- You are now ready to get started with your GNSS measurements.
Number of participants
Training of the following GNSS measuring devices available
- Emlid Reach RS3
- Emlid Reach RS2+
- Emlid Reach RS+
- Emlid Reach M2
- Emlid Reach M+